egr-off Siemens Sid 301 S1221121002I0-8200566025-8200370793 renault megane

[overbooster]

hi guys give me a hand to close the egr?

[cinqueturbo]

I don't have any news on this.. I think you should simply remove the plug and DTC

[overbooster]

ok thanks a lot

[Errecinque]

I don't have any news on this.. I think you should simply remove the plug and DTC

I read very often that it is easier to remove the dtc on the siemens trovarebi controls. But there is a rule like that of the edc16 to find a "hand " without the sw the dtc on these ecu's?

[sportknight]

looking for the error code you find that it curves at the beginning of the map(usually),the cudice is in a curvetta low,then starts a curve, the most high,by lowering the peak clear the dtc,test with dtc remover on a siemens so you realize,then it will be easier to do so on the other

[sisco]

looking for the error code you find that it curves at the beginning of the map(usually),the cudice is in a curvetta low,then starts a curve, the most high,by lowering the peak clear the dtc,test with dtc remover on a siemens so you realize,then it will be easier to do so on the other

Hello sportknight, I'm also following I this post and looking at the file I found 4 0409, 2 of these seem to be interesting exactly to the addresses 0413E0 and 0413EA, 0407 I found 10 0415E0-0415EA-041600-04160A and so on until the tenth (close by), can you say specifically how you should proceed to clear (if you go of course)

[overbooster]

P0409 - P0487 plug detached. I tried looking for them, but you repeat too many times seem all the same

[legendaryslave]

vc power proposes a solution I never tested it to try

[cinqueturbo]

Also the team professionalchiptuning has the solution..
just refer to the miss the blonde on the right

[andrea80]

This you do by removing the plug of the egr. Then turn on the error and read a diagnosis on what is.... With dtc remover the remove quietly.