weld schedule magneti marelli for the 1.3 multijet

[tuningecu]

good evening to all how to weld with precision the e xxx magneti marelli for the 1.3 multijet

[cinqueturbo]

The trick that I used and take a piece of cardboard, and soprapporlo to e xxx,
take the needles and piercing it, then move it away to the right distance and solder..
a recommendation that I give you and not to skip it too long..
pi? long is pi? flex...

[sisco]

I can weld the bosch I put it on the jig, the socket where it mounts to the processor of the pc, that has tiny holes where I hit all the needles that are passed to the e xxx, perhaps it may be well also for marelli, it is to see the distances of the holes

[obd75]

my ? a system with a p? rude but effective,I soldered on each pin of e xxx 3-4cm of wire, each of a different color cos? not scambire, and so how the f? when his upa,I connect the wires matching on the ecu, cos? there are risks, the connections uncertain or another during the work.

[matteo87]

my ? a system with a p? rude but effective,I soldered on each pin of e xxx 3-4cm of wire, each of a different color cos? not scambire, and so how the f? when his upa,I connect the wires matching on the ecu, cos? there are risks, the connections uncertain or another during the work.

if you have to solder the wires on the ecu might as well not have it at all the e xxx!! you can not find!? comfort? ? just that.
however, in order to weld I took a sponge and fisato the needles spring in position on the e xxx and on the sponge and then welded the whole

[Exelion1986]

The trick that I used and take a piece of cardboard, and soprapporlo to e xxx,
take the needles and piercing it, then move it away to the right distance and solder..
a recommendation that I give you and not to skip it too long..
pi? long is pi? flex...

also, I have done so?, some were not drittissimi but by forcing it slightly to the hand, I was able to align them well

[tuningecu]

ok, thanks a lot to all