Marelli mjd6f3

[vale76]

Good evening, I have a galletto v53 clone, I should read a marelli mjd6f3 (spansion) grande punto 1.3 but in the identification phase , after it has passed some minutes I get the following error:
ATTENTITON: Send file C:\Gallo\FGTECH V53\FGTtechfree\EOBD2_LOG\eobd2_100550_ERR..gal to
Remember to always specify:
NR tool
NAME & SURNAME
FIRM or COMPANY
Model of car
Type of Ecu
DRIVER USED
Also attach FILES, and LOG useful to solve the problem.

and do not go forward, what does it depend on? Previously, I have already read and written in the obd other marelli mjd6f3 (spansion).
Thanks

[vale76]

I will add that later while I was doing the data acquisition of a bosch edc16u31 to me ? appeared for a moment-the same error but immediately ? removed and ? went ahead normally.

[legendaryslave]

According to me, you're not ok with power supplies or connections

[polini]

make sure you put the e xxx over to the pitches

[alex68]

Good evening, I have a galletto v53 clone, I should read a marelli mjd6f3 (spansion) grande punto 1.3 but in the identification phase , after it has passed some minutes I get the following error:
ATTENTITON: Send file C:\Gallo\FGTECH V53\FGTtechfree\EOBD2_LOG\eobd2_100550_ERR..gal to
Remember to always specify:
NR tool
NAME & SURNAME
FIRM or COMPANY
Model of car
Type of Ecu
DRIVER USED
Also attach FILES, and LOG useful to solve the problem.

and do not go forward, what does it depend on? Previously, I have already read and written in the obd other marelli mjd6f3 (spansion).
Thanks

spansion laws in the bdm with the chicken.in the obd often I read maybe the other ones that you think spansion were not .

[alex68]

make sure you put the e xxx over to the pitches

pol, he speaks of the serial for the moment.

[vale76]

I'm sure it was spansion why? I opened the only difference that it was a 90hp and this ? a 75hp.

[vale76]

I open why? I thought of doing it with the bdm100

[passione motori]

Hello, I think that things are a p? pi? complicated, both ecu's work in the can-line, first change the usb cable and use one of good quality?, then make sure the contact between the tool, mini gender, obdii cable, if ok then try to read another ecu in the can-line if the problem persists do the mod. the tool

[vale76]

I have already? tried to read other ecu and after that, I had no more problems.