map pedal alfa 147 jtd 115

[fabio]

hi guys, can you confirm that the one that I attach ? the map pedal 147 jtd 115hp ? also can you tell me if ? just read it from right to left? each curve represents a certain percentage of the load (y-axis) on the x-axis c'? the number of revolutions and finally about the z-axis there are the nm? last question..why? there are cos? a few curves, and there are those that are very up-and-down ? sorry for all these questions but a little bit at a time, I want to understand how it works, this edc15...thanks

the map pedale115cv.rar

[ugoboss]

absolutely not that.

[fabio]

very good XD, so if you don't ? this sar? the one that the ecm called enrichment and acceleration (tell me that at least this ? right there I realized na bat XD)...why? in the map enrichment and acceleration values seem to me to be the one diesel, in fact, do not go over 70 if I'm not mistaken that correspond to 70mm3 fuel injected....look confirmations

[fabio]

ok I managed to make the screen and put it on dropbox ...this ? the map I talked about earlier

https://www.dropbox*****/s/4bh0ekbzna...2008.22.40.png

[elettro72]

is that ? the map of pedal in the axles you have ,rpm ,percentule pedal, and diesel mm3

[fabio]

Perfect... It reads from right to left? I see that the pi values? low you are to the right

[elettro72]

it reads from left to right as all the maps on this ecu

[fabio]

Then to turn the pi? high diesel fuel is cut? ? for this, after the 3500 pulls less?

[fabio]

another question, increasing the values of this map I noticed that the last curve that corresponds to 5500 rpm ? this, I leave it so or can I create a new curve based on the previous values ?

[jack91]

ah, and then, and then type the point 1.9jtd that after the 2700g/m has the cutting power?