59f m3 hw303 blocked during the scodifica

[giary74]

Good morning to all.
I did a partial on this 59F, but during the procedure scodifica you ? an error occurred and now I is pi? recognized.
I read with galletto old, in the Boot making the hole on the side.
During the writing phase, for?, after you have cancelled, you ? locked and me ? appeared error 4 (if I remember correctly). In the sequel, the "change of speed?" seed...
In fact, now the ecu is not recognized n? from galletto 1080 from gallo2.

It is the first time that happens to me with the 59F and I don't understand the why?.
I realized, with the cock 2 that the output voltage was less than 12v. It is possible that the problem is due to the power supply?

Previously, I used a battery coupled to a battery charger to charge slow and I never had problems of this type (only once with a 5F if I remember correctly).

You can? do something, or ? become a paperweight?

[giary74]

Update:
Today I made another one with the gallo2 fed to 12.4 v and ? everything was in good order.
Sar? was the fault of the power supply?

[alex68]

try to make the id, and in case you make change hdw.

[giary74]

try to make the id, and in case you make change hdw.

but with the gallo2 can I change HDW?

[alex68]

no appropriate interface, if you have problems in the event mandamela you the way I do it hello