hi,
I wrote a Marelli combining the FLASH File to be modified, it to a file MICRO.ori originating from the control unit with the same SW and HW, but with the number "Spare different". The drive part and seems to be going well. Wonder what the file contains, MICRO that the program asks to join the Flash changed?, There may be problems later on?
Thanks to anyone who can answer it.
in micro ec the sw to operate the flash, very likely having the numbers sw and hw equal was fine, if the car goes in motion and goes well you should have no problem in the future, but I ask you, you couldn't have read his so you did not run any unnecessary risks to secure everything?
ugo ---- president A.E.P.
Thanks Boss. I confirm what you say, the car is like with the old file. Only problem is the error p1901 to the pressure sensor of the FAP that I thought to solve with the luca stanca... but still present. Then I close the discussion by stating that even in the case of writing as I made the drive works. To answer your question BOSS : I tried to make the gnorri avoiding 1 hour and a half of reading, the required pe is ceases to ECU. Now I open a post for the error P1901.
in order to avoid an hour and a half of reading, I open it and I do it in BDM 10 minutes and problems 0
ugo ---- president A.E.P.
Quote
