hello all,
I try file ori Alfa 164 TS '93 because my TL866 can't read the eprom 27c512, I have a lamp ultraviolet to erase the memory, but I need a owers on which to work.
dispondo a Galetto V54, by any chance do you know a method to open the control unit on how to connect the galletto to extract the files ori?
You need at least Code HW & SW I don't believe there is only one type..
27c512 take it new that does not always go to the erase and programming..
I would also check if there is an alternative compatible more new type 28F512 29F512 W27C512
with the Rooster you can not do anything on this ecu..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
HW 0261203847
SW 00464663990
The control unit is those that do not have the spinterogini, but the coils in the ignition module of the ignition and lambda probe, wiring mounted on the second Alfa 155 8V and the first Alfa 145/146 just to see what kind of hardware we are talking about.
On the eprom I took in fact 3 eeprom W27C512.
I need the ori on which to work, so I make the map more suitable for the middle
Hello Andrea, I have the file with the same number as the sw but I have 2 with the same number as hw. Test... to the maximum. Unfortunately, I did the same thing with a 8f and anything without reading it completely unusable.
I had forgotten the attachment...
your ecu should be a bosch M1.7, but if your programmer can't read it you're convinced they're able to write it?, in any case, these also with the sw several were in motion anyway.
ugo ---- president A.E.P.
Watch Ugoboss unfortunately I experienced the same thing with a 8f taken from the demoman who once welded the 27c512 are not able to read it, and 27c512, I have read at least a dozen with my programmer.. Probably I heated too much and is missed.. So it could very well be able to write and read of the other.
Quote
