Hello Elmino,
I have a GP and on my ELM327 1.5 a I had to delete a terminating resistor... 120 OHMS, which puts you between CANH and CANL
Unmount the ELM 327 and pulls the card out of the.... I in the meantime, I will take a photo of the point where I've taken off the resistance I
PS: I Had the same problem... not connettevaed andavain error.
Hello
Hello thank you...to then see the image that places like I do? I thank you in advanceOriginally Written by albertoS4
You are right... post pictures of your card and I'll tell you what you need to change...
otherwise you have to wait quite a bit.... :-(
if you leave the address and -**** you can send them to me the photos? Xk nn I know how to load
you could help me?
AlbertoS4????
Cia, I also have a ELM 327 v. 1.5 (a) (before I had a 1.4 modified, but this is totally different).
Version-U03AJ_M "1.5"
dated 2016-05-16 (I found the same initials on another forum but the previous version had the numbers of the resistors, not mine, and parity of the acronym on the board, is willing whit)
This does not work, does not connect to the... is not recognized... the cd driver is useless.
elmino follow the tracks of CANH CANL on the card, resistance to be removed is located between these two lines
on resistance, there is written, 121, that would be 120ohm
what you describe is a driver issue of windows...Cia, I also have a ELM 327 v. 1.5 (a) (before I had a 1.4 modified, but this is totally different).
Version-U03AJ_M "1.5"
dated 2016-05-16 (I found the same initials on another forum but the previous version had the numbers of the resistors, not mine, and parity of the acronym on the board, is willing whit)
This does not work, does not connect to the... is not recognized... the cd driver is useless.
Write permission
Quote