KESS V2 MY works 100%

[ecuprom]

From the point where the 2 red lines, ? where you solder the 1N4148

[ecuprom]

I sent a photo with two red spots, ? where you have to solder the 1N4148

[oakley1]

perfect now ? clear.... I'm going to weld thanks

[ecuprom]

The whole question, please tells me

[nox]

Oakley when you're done you can make a detailed guide on this site even though I got it right ! And especially as the protocols are activated

[oakley1]

nox, therefore, you need a diode 1n4148 look at the photo that he posted ecuprom you have to solder in the pins marked with red dots..not mistake the polarity .with regard to the protocols unfortunately ? a problem of the fw... we don't have the updated one

[ecuprom]

oakley1, has tested the change?

[nox]

I have on hand a kess and also the k tag a friend, the two of 1.89 xo on the ktag protocols are all enabled, while when I connect the kess protocols trucks vanish except someone to Renault , then as I understand, however, the change will improve? however, the operation ? The polarit? and that of the red arrow? Thank you very much

[oakley1]

not yet, for now, I have not edc15 to try....you ecu have you tested?

[oakley1]

the black dash that I designed on the diode matches the indent of the bill... the amendment does not implement the protocols, but it goes to obviate l is impossible not to read the edc15