problem of bmw 330 xd

[manu90]

test tecnomotor as a diagnosis on a bmw I know almost always defended well.....

We tested with the diagnosis bosch, texa, marelli, gutmann (the only one to have the reset of the pressure regulator and many more adjustments than the other) and now even with the official tool

[tecnoracing]

Hello Excuse me I'm intruding have you checked the wires going to the pressure sensor rai on the back side of the flute, they break often, even if looking at them they look good and are broken inside

[manu90]

Hello Excuse me I'm intruding have you checked the wires going to the pressure sensor rai on the back side of the flute, they break often, even if looking at them they look good and are broken inside

If it was a broken wire it should give a error in power supply or a bad signal, instead of in the diagnosis it is all ok, the pressures are perfect

[tecnoracing]

happened to me and several times and no diagnosis there were errors once only I found rail pressure

[tecnoracing]

try to move it while in motion

[manu90]

try to move it while in motion

I checked and the continuity is there, even with the oscilloscope attached, the signal is always there

[tecnoracing]

which of the two signals on the sensor rail pressure does not find the signal, you will find a power back that is 05v on control board turned on, and varies according to the pressure ol segnrale find on the pressure regulator is not in the sensor