-
I have tried to do a post guide to make a Bit of clarity(but do not ? been considered), but I see that c'? always pi? confusion!
What the f? different about this tool compared to a serial programmer? If I'm not mistaken you always connect to the k line? Since it does not need any bootmode, adr? write through the k-line or not? For scodificare the ecu, totally or partially, where it is necessary to intervene in the e2p or the flash?
-
I did a reading and writing to the tour, but without the boot for a 5am....I don't know if it is similar... HW>100....and yet I knew that for this cock was made the boot....doing the hole does not open...
-
in fact, the hw>100... my m3 ? <100 (hw023), I recommended a tool which is little expensive for this ecu?
Write permission
- You you can not post new threads
- You you can not send answers
- You you can not send attachments
- You you can not edit your posts
-
The rules of the Forum
Quote