body computer alfa 147 jtd 140cv test bench arrow right rear

[todos]

replace it in the sense you spend 500 euros ??

advice?

hello itama,or saw the body ch? I and or given a look, you have to make some welds on the tab of the body on the side sinitro there are components that are easy to ch? you disaldano near there are 2 small rel?......

[giuseppe1374]

replace in the sense that you take it to collapse for 50 euro and then throw the contents of the e2p micro

[motorsport]

replace in the sense that you take it to collapse for 50 euro and then throw the contents of the e2p micro

the exact and the best solution!!!!!

[itama]

the exact and the best solution!!!!!

is the solution to lower the price and that ,always crossing our fingers that the body is in good condition .
aH, one thing just to have inside the chip motorola of my body, or should I watch it?
move the content you intend to unsolder the chip from motorola of my body and put it on the one retrieved from total collapse?

[todos]

is the solution to lower the price and that ,always crossing our fingers that the body is in good condition .
aH, one thing just to have inside the chip motorola of my body, or should I watch it?
move the content you intend to unsolder the chip from motorola of my body and put it on the one retrieved from total collapse?

itama, you can make a copy I disaldare the eprom and put it on another body.....

[itama]

what equipment it takes to make the copy?
the desoldering and soldering or hot air????? if you decide to move the chip to

[motorsport]

upa/x-prog + station hot air!!

[itama]

upa/x-prog + station hot air!!

then if I move the only motorola just the station hot air right without resorting to
The UPA ?
but the body recovered from the collapse, just to have on my motorola cowboy way, or you have to look for another one?
someone has written that in the zone relay is highlighted in blue can I find something unsoldered but I see everything is ok-controlled lens as you can see, it would seem everything is welded as I understand it, it all seems fixed

SEE ANNEX
IMG_20140109_191112.jpg

[todos]

then if I move the only motorola just the station hot air right without resorting to
The UPA ?
but the body recovered from the collapse, just to have on my motorola cowboy way, or you have to look for another one?
someone has written that in the zone relay is highlighted in blue can I find something unsoldered but I see everything is ok-controlled lens as you can see, it would seem everything is welded as I understand it, it all seems fixed

SEE ANNEX
IMG_20140109_191112.jpg

you hot air, and a saldtore with the tip of the fina..

[giuseppe1374]

all depends on your degree of preparation, if you are familiar with soldering, you can switch the micro, but if not, l've never done it yourself, I recommend you do the damage, then the choice is up to you, who shall judge on the basis of your familiarity, what about the reading and writing I see it as a thing feasible, even if not l've never done it with a little help from colleagues in the forum would you be able certainly, the body must be diesel as your and about is also the year of manufacture, if you see it with your own code, go safe, at the end you only have to pass the e2p of the micro-code or keys always depends on what you want to do, I hope this information was useful, in regards to your problem you already have? tried to activate with the diagnosis?