Opinion on file Alfa 156 MOD

[romeo156]

A hello to all!

put the mod file and golds of my alfa cos? we take a look, I changed a little everywhere, ignoring some of the map maybe this is not useful to me!!
I lowered the suitable and the rail, the torque of the turbo so just the one that I need to have a map soft!

if I made some map, be patient with me and kindly give me a hand to understand some things, e.g. how do I see what is in the press. rail and the bar of the turbo!?

I work only in 2d, with the table I'm working on that but I don't know how to read the how much, and how to make the changes .

thanks in advance to all...

[romeo156]

No one is willing to give me a hand?

[SandroMarciano]

The rail to display it, by multiplying the value for 0.1 cos?cch? 13500 becomes 1350bar.
The turbo instead of the display in mbar, and expressed in absolute value = relative pressure + atmospheric pressure. For example, if you read 2350 knowing the atmospheric (typically around 980mbar) that the relative sar? 1,370 bar

[romeo156]

The rail to display it, by multiplying the value for 0.1 cos?cch? 13500 becomes 1350bar.
The turbo instead of the display in mbar, and expressed in absolute value = relative pressure + atmospheric pressure. For example, if you read 2350 knowing the atmospheric (typically around 980mbar) that the relative sar? 1,370 bar

thanks Sandro for having responded to me, have you taken a look at the mod?

[giuseppe1374]

if you have a diagnosis, go up and controlled the objectives with the "actual"..

[romeo156]

hello joseph, and you believe I following your advice I can translate what that says to me the diagnosis!? I am not a professional and not cos? as good as many here in the forum, I have just started to understand something with the ecm and I need advice how to use it... it would not be pi? simple if anyone of you who has more? experience you watch a 2-minute mod and I translated the thing and too much, and what little changes in two lines? I have checked and re-checked the map after reading some topic about the edc 15 and following the advice of lupak! I noticed that I started too low with the changes! if someone explains to me how to map in both tabular and where you read the rpm?
or in 2D by increasing, for example, map the pedal how do I figure out how many rpm childbirth? thanks in advance to who ? willing to lose 5 minutes with me. good weekend to all

[ne0h]

The Ecm on the X-axis always displays the load on the engine even if in reality? ? the other thing, personally I suggest you to use winols,
much more? professional and complete...then it's not? if there is a way to make people read the real axis to the ecm
If you find difficulty? to locate the maps, you can always look at the address from the driver in the ecm and search for them in winols..