Edc15p tdi 101 seat,some doubts on the map

[jolidj]

well according to me and a fix.

[munro]

the X-axis ? the air flow rate, the Y-axis ? the no. of turns, if we take the case Z ? almost always equal to X, then according to me ? a correction of the measurement of the air mass as a function of rpm. Increasing it ? how to increase a limiter fumes

franco sorry ....just to be clear....but according to you, qul'? the x-axis??I am in the map I see, starting from left to right the third peak that v? on top of that ? the Y-axis that is up to 55000..then the X axis does not reach to 5000, and the Z-axis and moddato in the map that comes to a max of 10000 ori and p? more in the curve mod...

[franco75]

ok, swap x with y.
The y-axis, that comes to 55000 in the last value to me ? the mass air flow sensor. If you exclude the last value only to me ? a sort of scale, the values of questasse you, you will find them in the Z-axis.
Ex: if you have 5000 mass air flow sensor, map, will give you 5000. There are fixes only speed zero to the curves from 2 to 7. for the rest you have in the output from the map the same input value of the y-axis.
I hope I was more clear

[munro]

I don't follow I'm sorry.....according to me the order of the axes ?:Y>X>Z.
now in Y there are 55000 scale a mass air flow sensor stuff like this not the law as being a edc15 law the air in mg and the maximum you can? read in mg are less than 1300mg that in the map I think that would correspond to 13000 full-scale...then in the bottom of the scale of the Z-axis I will read a value of 10000 or slightly more.....I don't understand where you see the same value in the x or y axis pressure that are......

[franco75]

perhaps it would be appropriate to speak with addresses in the hand and not with a photo

[munro]

[franco75]

Watching a file of the type known to the xaxis ? a temperature, it goes from 2531 to 3431.
The peak that you indicate actually ? besides the map.
If you go at 6000 or more in the Y-axis in the map you will find the same value regardless of the value of the X-axis
In conclusion, according to me ? the correction of the mass air flow sensor as a function of intake air temperature.

[munro]

for me in the axes c'? in Y iq,55000, which may be 55mg and X I see little 5000 that could be rpm,while in the Z, I see a value from 0 to peak at 5000 and go "altalenando" up to 10000....that honestly escapes me as to what could be....
The Magi are you there??what do you think of this map???

[sportknight]

? a limiter, diesel, according to me,otherwise I can not explain why? all the change in parcentuale

[munro]

it could also be a map n75 duty cycle for?....