The Punto evo 1.6 120 hp 2010

[blackwolf76]

Should be the same mechanics of the bravo, which I have read quietly with mpps5...

[panterargento]

Hello to read this ecu K-line, you need to bring it from the engine control unit to the diagnostic socket, the network k.. as on the diagnostic socket( obd )? this only the can network.. the procedure to run ? this: connect the pin 25 connector To the wiring side of the engine control unit to pin 7 of the obd.. after that you can use any of the read protocol edc16 c39

Not ? maybe there st? any help...? Maybe a step by step procedure...a few more might be useful.

Should be the same mechanics of the bravo, which I have read quietly with mpps5...

I have already? tried with protocol good...but nothing.

[blackwolf76]

For the mode? reading via cable, k ? simple enough, you can disassemble the unit and make it to the tour, all you need is the pin numbering of the controller, which you can find on the banks ' data type ********.

[maxsek]

but do not make it in the bdm and giacch? you equal your ass???

[panterargento]

I think that if I had the bdm, I would have already? done...

[blackwolf76]

I think that if I had the bdm, I would have already? done...

if you can? of interest I have a template with a schedule for the bdm, and a rooster v2 that they give me...

[panterargento]

For the moment, no, but terr? in consideration of the proposal.