Page 2 of 3 PrimaBefore 123 LastUltima
Results 11 to 20 of 26
  1. #11
    THE AVERAGE USER
    Date Of Registration
    Nov 2012
    Messages
    251
    Probably if ? gi? been made to the reprogramming tells me that pu? be the CAS, to make the start-up must have the consent from the ecu of the engine, maybe lose the communication on the can and disconnecting and riattacando the ecu realigns, pi? this knows, the problem of the battery cable instead ? on the 5 series, I was wrong.

  2. #12
    THE AVERAGE USER
    Date Of Registration
    Dec 2012
    The resort
    genoa
    Messages
    82
    check on the battery that will ? a cable on the mass with the fuse. that surely ? missing the one.

  3. #13
    THE AVERAGE USER
    Date Of Registration
    Oct 2012
    Messages
    300
    Hello, what ? the CAS? where is it located?

    thanks

    P.S. For *********PRO if it had jumped that fuse the car should not pi? ride your bike or it could make jokes that point and in the white leaves you to walk?

  4. #14
    THE AVERAGE USER
    Date Of Registration
    Dec 2012
    The resort
    genoa
    Messages
    82
    not to be in motion. in some cases I or e90 with edc16 me ? also happened that it was the engine control unit went

  5. #15
    THE AVERAGE USER
    Date Of Registration
    Oct 2012
    Messages
    300
    Hello, as I assumed, was that the machine should not pi? starting, here, however, when it comes off the ecu, reconnect and the car starts without any problem....

  6. #16
    THE AVERAGE USER
    Date Of Registration
    Oct 2012
    Messages
    300
    ...the CAS ? the ignition control module? where you insert the key to start/stop.....

  7. #17
    garret
    Guest
    have you checked the smart sensor ibs? often on the bmw ? him to give you problems, I on my I the ibs is defective and sometimes it would not start why? it gave a absorption to ****head of energy management, the battery went from 12.8 v to 9v and went on tilt, also on my e60 530d I have replaced the wiring deol, respectively positive battery cable under warranty as the recall of the official, after all these operations I ? on light drivers, with autocom I gave over voltage positive battery cable, the positive terminal c'? a connector that was loose and oxidized, I clean and tight with a pliers, the 6 months that I have cleared the error and not you ? yet resubmitted

  8. #18
    THE AVERAGE USER
    Date Of Registration
    Oct 2012
    Messages
    300
    where is this sensor?

  9. #19
    THE AVERAGE USER
    Date Of Registration
    Oct 2012
    Messages
    300
    In some of the details in the pi? on the errors found by diagnosis:

    cable - to-wakeup (on-board network 12h) or terminal 15 (on-board network 11h) code. 4A03
    - power management on-board network code. 4A66

  10. #20
    garret
    Guest
    practically on the negative pole of the battery connected to the negative cable, c'? a sort of box with black, from which exits a thread, molded plastic, black, all ? connected by a connector in the turquoise waters or at least on mine ? cos?, this box adjusts the energy management of the vehicle, both the vehicle and the engine, if it fails to work, the management of energy ? correct, and sometimes the car will not part

Page 2 of 3 PrimaBefore 123 LastUltima

Write permission

  • You you can not post new threads
  • You you can not send answers
  • You you can not send attachments
  • You you can not edit your posts
  •