Insights on file ORI read in from the serial port and BDM

[zioweb]

there are programs that calculate the cecksum as winols and ceckcorrecctor up-to-date, for otherwise there you will find the marelli, however, from what I remember of the mpps v12 when you can not calculate the cecksum,usually in the c'? the key check there clicking over and asks you to load the file ori and then the modified one,corrects the cecksum and asks you if you want to write

correct.

if in case you have a file that is read with mpps of 2mg and write hangs, can you? riutillizare that file, editing it just in case, to rewrite it in the bdm? or c'? only need the bdm backup?

mpps does not read from 2mb, but from 1mb only the 1.3 mjet. If you want to check the file 2mb bed with magpro in serial on the 1.3 mjet with the bdm just find the backup of the software version that I read and I see I found I did not.

[explode82]

correct.

mpps does not read from 2mb, but from 1mb only the 1.3 mjet. If you want to check the file 2mb bed with magpro in serial on the 1.3 mjet with the bdm just find the backup of the software version that I read and I see I found I did not.

file ori I have to deal,enough that I posted the id of the ecu 1.3 with HW and SW

[zioweb]

file ori I have to deal,enough that I posted the id of the ecu 1.3 with HW and SW

Pi? that ori we want to backup the flash bdm to verify the address.
If you want what I have ? the Lancia Ypsilon MJD6F3HW03T sw 3459Y395

[dvdtuning]

I understand...you can read the eprom seen that the flash ? cleared and cut, right?

[dvdtuning]

no, edc16c39 the law in 2 mega!

[zioweb]

no, edc16c39 the law in 2 mega!

I was referring to the mjet marelli with which I began the speech in the first post.

[explode82]

I know and also I was referring to the marelli

[gfr]

I lost my head even if I do only 1 mb or 2 mb, but at the beginning there is nothing, I do not agree with the bdm, the flasks to me is always equal to the full read

[explode82]

can you explain that,to be honest I did not understand what you wanted to say

[explode82]

regarding the files that I have all the beds in the bdm otherwise I would not have said, and more? ori,if you need the program, I do understand where and how to post it and I will put them even if around the is