rev limiter edc17cp04

[Supercharger]

I don't know why I do not upload attachments...it tells me error; I did, as usual, advanced mode, manage attachments, but when it loads it then says error

[munro]

it is not necessary that you post the file if you've done all correttmente..
the method which is the safest and the one to load the map into the ecu..
then if you still want it to be at peace with the mind..ok look you can give..
a council is not to set it too low 4000 rpm, according to me, are a bit short, especially on an engine as fast as the bmw and is easy to find oneself in fourth or fifth gear at the rpm set in the rev with the car that pops..
alzalo a 500-800 rpm...

[Supercharger]

perfect the load and let you know...I agree with you regarding the rpm of the rev the sposterei at 5000 rpm it was only for test...
thanks again will update as soon as I did....thanks a lot

[Supercharger]

just tried the rev is not part...comes in, the limiter is normal at 4000 rpm precise can be caused by the fact that in the table I put everything to 0 from 4000 onwards? and maybe a 4000, I had to leave the original value?

[Supercharger]

thanks a lot for having guided you up to here...I did the rev it works...only that even if I set it to 4000 rpm for the test kicks in at 3000....the scoppietti does them well, but after awhile it is as if it disappears and remains the limiter normal...surely I made some error, place the file maybe I can fix thanks again...

[munro]

not you need to reset the axis of laps, but only the surge after 4000 rpm......
the axis should be changed only after 4000 where to see it written 8400,i.e. 4200 rpm, set everything to 8020 so that you have the cutting rev 4010..
you aevo made a file but can not download so that you can not do anything about it..

[Supercharger]

thanks so much again for the support...your explanation is very clear but once you open the map came to me in a bit of doubt...
Then, starting from the first limiter to the address 058060 (8400rpm) I set everything to 8020 up to 058062 then after if I have understood correctly I should do the cut out on the limiter following that, however, is a panettone and a constant 5000rpm it down all at 4010?
on the second I did the same thing all at 8020 but in the panettone I have strange values with a peak of 3867 to address 0580e6 .?? how do I act?
as far as the last lim I did the same thing on the ramp and on the limiter, the next value to 4000 rpm the I have cut down to 0
can you please post the file for clarity ...thank you for having prepared the file, but unfortunately have not yet arrived to 80-mex

[munro]

every patience has a limit...
if you don't understand I can't do anything..

[Supercharger]

Sorry if I made you become mad...you're only able to postarmi the file that you had prepared so when I get to 80 messages failed to understand?

[Supercharger]

please