Have you looked at the map well?
Enrichment in the acc and hurt because you have a 57% increase, to finish at 3% which is too high at the beginning and disproportionately low at the end
Rail pressure of 0.9% almost anything,from 4000giri and ori as ever?you can also go to a 7-8% or even more depends on what you want, the similar maps made bad check the map 1 and tene notice
Turbo pressure 110punti are low, you can raise it,parts from rpm lower
Pressure turbo f(temp) 30punti below are few and 240 at the top are too many
limit torque parts by 2700giri, too high, and increases in too low of 3.5%on this type of car can go above 18%,the same applies also to the other torque limiters, and above all, you have to check the maps related to the latter, a
Pressure limiter turbine 100punti then the lower pressure turbine
The second limiter press turbine instead 220punti why?
Limit press rail 0,3% ??????
What has become of the injection ?if you do not get up in this you can give the whole pressure turbine,rail,or arr in the acc, but you never get the right results
Too much theory is not good it also takes practice to make go fast a car otherwise you are likely to consume the calculator doing all these calculations
Originally Written by admin
Have you looked at the map well?
Quote
