Good evening guys, I have a question to ask you... given that the punto gt ? no obd from what I know you have to remove the chip (fortunately, the car in question have already? proceeded to weld the clogs)
should I then use a USB GQ-4X to read and write to the chip without too much difficulty on win7 and via usb, but the real question ?? ? can be able to read the drive in question with the KessV2 or the Cock v54 that I have already??
thanks a lot
you should buy an eprom programmer type willem with que
llo you should read and write to the eprom
ok fine, but my question is always if ? can read this type of car with the KessV2 or Cock V54 in any way via obd\3pin etc
with the kess v2, you can't read it, the only way on these cars a bit older ? as described above
I have found the USB GQ-4X for win7 and ? gi? usb, I know that someone uses it...? I also know someone who reads without removing the chip ...
this I could not tell, but the eprom ? zoccolata?
Yes , fortunately it is already? zoccolata
I suggest that the programmer costs just put it on and read and write
these do not read nor the write by obd, have the eprom and not flash, then dismount and you read and write to the tour, and to write them down, you have to first delete rays with u.v. (as long as they have the louver)Originally Written by darioz90
ugo ---- president A.E.P.
Quote
