lambda probe iaw 8f

[LL205gti]

because to me is that the probe is warm because I want to use its signal to a different purpose from the reading in the ecu. the probe reads the wrong if not ? at the correct temperature.

if detachment of the connector I have is that the probe does not read well and the ecu ? in the recovery.

I would like that the probe scaldasse but that the control unit does not react with the fixes.
I was pi? clear now?
any advice?

[sergiot]

leave the probe connected to the control unit for the heater and picks up the signal from the probe by interrupting the connection to the ecu and diverting where you need them