Flash map Ducati Performance ECU original with MPPS

[m999]

Clarification: the file read from the MMPS ? from 320kb why? in you also the reading of the e2p, the file you found instead ? only the flash, 304kb. Software with ECM type, but also with a player hex if you can (go to copy/paste the first 4000 addresses of the file in hexadecimal), you could pull out a file full 320kb. The fact remains for? that wouldn't have the correct checksum and the risk of lock the unit in writing.

Another point: the file Ducati Performance sure that it is suited to your bike for as ? the mass of the exhaust and air filter? You or less of the catalyst and the lambda control?

Eye!! Do copy/paste with a file that you do not know without knowing exactly what you combine, they do damage!!

M999

[maximumwarp]

Ok, thanks, now the ideas begin to clear...
It seems to me that you are confirming that ? can read and write to these control units via MPPS.
Reading the ecu directly from the bike I'd get a file from 320 KB then, with a hex editor I could take the first 16 KB of the original file and add them at the head of the file DP in order to regain a file from 320 KB (then written in the ECU via MPPS) but there would be the problem of the checksum.
At this point, the questions remain 2:
1. The bytes to be fetched via hex editor from the original file are those from address 000000 up to 003fff, or until 004000? According to my calculations it should be up to 003fff...
2. Made this "copy & paste" of bytes, not c'? way to correctly recalculate the checksum?

I would add that it is physically impossible I still have the bike between your hands, then I can not control catalyst and lambda probe, I only know that mount exhaust Arrow-approved (but with dbKiller off).