Iaw 16F scodifica from micro

[mecdoc]

I did the test to unsolder the micro, but nothing to do. When I do Read/ write always gives me the error. If I try more? times can you read a file incorrectly

but the oscillator will you put it?

[Elettrico]

I bought the interface and sw full of shoe do I do it without welding and without having to disassemble anything in 20 seconds ago total.

[Gia]

but the oscillator will you put it?

it was just what my error

[mindafuttu]

But to be put on or off the oscillator?
I have a similar problem with the mcu mc68hc08az32a, I don't understand where am I wrong.

[alex68]

But to be put on or off the oscillator?
I have a similar problem with the mcu mc68hc08az32a, I don't understand where am I wrong.

not go crazy if you send me you do I

[mindafuttu]

Thanks a lot alex68 x the availability, I solved it with the upa, but my question ?: as ever, both by the connections on the pcb by soldering the processor on the e xxx(without oscillator), I was not able to read the damn?

[Mr.Flash]

for these ecu c? a swap file, use a 27c512 with this file, the balances on the ecu then feeds the ecu for 30 seconds dissaldi and re-mounting your original eprom, nothing more? the code you put only remove the lamp failure immo on the instrument panel

hello passion motors, I have seen your message and you would like to report this attachment that I added a little while ago , could you tell me if ? correct ? thanks in advance

http://www.professionalchiptuning.ne...ll=1#post83567