try putting the original turbo or diminuiscilo a bit, or lower the pressure of the boost even if you don't you have touched abbassala some type 5-6 %
try putting the original turbo or diminuiscilo a bit, or lower the pressure of the boost even if you don't you have touched abbassala some type 5-6 %
the log *********** have been made with the original map, no dpf, no egr, no swirl..
since ? a automatic I abbasseri a bit the couple, or would delay rpm increase...
I had a problem of recovery on a drive the same, and it was the solenoid that operates an overboost.
Changed and fixed everything
ok thanks...
with your report of the turbo... I went to look around... and I saw that I have a great trasudo from the tube ic....
can it be that I have soiled.. the actuator.. and it doesn't work as it should??
I can't see him.. I should watch from the below.. in the meantime, I enclose 2 photos..
dusted this discussion..
at a distance of 8,000 miles... and 4 months ... I have not had a recovery... (finger tip.. hihi) the car now and no egr no dpf and no swirl... everything has to be detailed and physically...
ie.. plate on the egr and dpf..... in the garage.. and swirl removed..
according to me... the problem was just the map at this point.... because it has no more made jokes...
I'd be tempted to load another... but I'm afraid.. go still in recovery...
if it was the map... what could it be???
Good question e-mail ori and mod!!![]()
You do not really understand something until you can explain it to your grandmother (Einstein)
the ori and in the database .. the mod and on the first page..
however, in the first page.. you will find the link to the database...
this mod posted... gave the recovery 100 km after you have loaded...
and always at the time of release ... i.e. after having given up the throttle... (engine brake.. and' auto') ripredere the throttle and I was in recovery without lights...
Hello I inizieri to make a map completely from scratch just to try to improve the yield and to avoid the recovery if the problem ? caused by the map. However, have you tried to connect the self-test to see if while if it goes into recovery, that kind of gives you the error?