hello to all alego-step guide x to repair the instrument panel of the renault scenic in the case where it loses the memorio or for dimming both partial and total display+parts list.
for the pass contact msport
http://www.sendspace*****/files/wcx4hu
hello to all alego-step guide x to repair the instrument panel of the renault scenic in the case where it loses the memorio or for dimming both partial and total display+parts list.
for the pass contact msport
http://www.sendspace*****/files/wcx4hu
Last edited by msport (exil77grande); 26-09-2012 at 15:19
hi can someone help me to solve this damn fault, despite having changed components : 12 resistors from 1 ohm to the mosfet, the fuse and the voltage regulator, the picture comes on but after a while of operation, it begins to turn off and on again
thanks to all those who will speak for your disponibillita'
I forgot the guide I downloaded, but I can't read why? I do not have the permissions
Last edited by andrew64; 06-10-2012 at 16:46
cio lost time I also.. I changed a lot of parts.. but nothing to do.. I never managed to fix it.. and frankly I have never understood the why? does not work!
If you have changed the components and that's not good including the integrated 8-pin ( near the resistors) in general, and him that is shut down and turn on the ignition, try to put the card on a table in the floor of the heated thoroughly with a hair dryer-hot air would expect that cools well and see if it goes on..,
cio tried but I got it I also the same results, nothing to doOriginally Written by audi sp
someone ? never managed to fix it?
I in addition to heat the shed where c? the feed to a temperature of about 250? I redid all the soldering of the resistors 12 more that which is marked with 300
and up to now is maintaining in the following we'll let you know if this worked
someone to info about it??
until now it works perfectly without giving any discomfort
Hello, I have not been able to see the manual, why? not c'? need to pass the descoprimir file.
Reading what comentais some here, I can say that in some cases, the file in the eeprom 93C56 ? damaged, and valid data must be loaded, it loads the file must be compatible with the version of the microprocessor (V6, V5, etc.).
The explanation ? the box receives and transmits network (CAN), if the file ? corrupted eeprom, the microprocessor does not generate the signal to turn on the box.
I hope that helps. Greetings
p.d.: ****** translator
I also, while I was going to change the resistance, I realized that they were almost all detached due to overheating of the plate. It took risaldarle all, and magically work again. If I remember correctly, the card, which was covered by a chain of plastic that limited heat dissipation. You could create some air intake on this chain, so as to facilitate the dissipation of heat produced by the components; I remember that the card was so heated that he took in shades of burnt!!! Does not harm to try.
Write permission
Quote