removes residues, but especially when you use hot air ? essential because is out of the pond with ease? on the slopesOriginally Written by FUORIGIRI12000
removes residues, but especially when you use hot air ? essential because is out of the pond with ease? on the slopes
message light, ? a good rule to appear before of write in the various forum threads
Last edited by leandro89; 04-12-2013 at 23:02
it would not hurt...a nice video to understand how to do...the procedure can follow...but, above all, see how to set up the work...
I would like to start to weld, and I do not have the rights to download the manual.Does anyone have a?the other option to read?
guys for my experience ( here the game in the house is my job ) I have long abandoned the welder normal, with a small investment, you can take a hot air welder as the small weller gas... with that you are not at risk of doing damage on the slopes with the tip of the soldering iron, very easy thing when you insist on, or when you put, and remove the components for this many times. If you want my advice, I when I started a long time ago to work on the plates complicated as plcc, then sodip, bga, and the overall smd electronics, I decided to do the tests on the motherboards of the hdd to understand how much heat and how to move. Unfortunately there is no guide that takes when it has to do with components, delicate.. you have to have a great experience and I assure you that the results you will see after the first few holes charred ...
Use soldering flux, that helps a lot.
Hello,
I use it to remove the IC or other electronic SMD a Hotair Rework station.
For? it can not be programmed (read and write) the data of the Eeprom diratamente?
With regard to the pond I found around rolls that were crap, not all have the flux inside...for a good weld, it also takes a good pond
Always use the tin with lead! If you use this without you always have problems with flux inside.
Write permission
Quote