elimination swirl opel astra h

[blackwolf76]

If ? 16 v I rimangi? the word

Trust that ? cos?;-)

[dvdtuning]

I confirm I have 2 with the same problems...then the diagnosis should see the real values before and after the mod and are not mounted? I know that the group opel there are definitely, in fact, I spoke with the mechanic asked me if you could remove the light once you have done the mechanical work.

[frantik3]

there are some 120 hp opel as the zafira, which are 8valvole, and have not then there might be versions that are 16, but I never happened to the ones that I happened to both opel and saab were 8valvole without swirl, but with management in the ecu

[tezzero]

Attention elimando valves sw open doors on opel 16v you ? generated an error that had to do with the speed? entrance of the air in the intake manifold by sending the drive in recovery (I don't remember the error code), not c? was nothing to do..I restored all the error ? gone.In my opinion, it was necessary to find the way to delete the DTC.

[blackwolf76]

I repeat that I have made patecchie simply by removing the swirl and leaving the motor without any error...

[cinqueturbo]

Me in curious trails this matter...
some problems "devastated"?
to others with no problem?

[legendaryslave]

I also confirm that I made different opel removing all the manifold including injection pump removed all closed the holes and locked by the map I never had a problem

[baraldino]

have you solved it?
last week I had a problem with an eighth note 1900 mjet eliminate the swirl from the map, the car was still in recovery because I had the electric motor locked
I have disconnected the connection and lit indicator ie but no recovery deleted dtc everything is ok

[dvdtuning]

By removing only the swirl physically without exclusion in the ecu, generates "dtc P1109 - high voltage circuit feedback actuator intermittent turbulence,"a time, excluding the error disappeared.

[marco]

hello dvd-tuning you have to take them apart physically made a dozen of these

They brought me the machine after you have removed the swirl and with motor attached. I have 2 with the same problems, I have to make a diagnosis and see well the error codes, if I can do it in a day.