Are those for edc17
Are those for edc17
Unshared knowledge remains an end in itself.
perfect!! thanks guys you have been very clear!!!
hello guys, as you do for the marelli 8df? I'm looking on the net but I can't find anything specific, I was thinking to build it, you advise me something???
If you have the desire and time to the build, but once you've taken manualit? solder does not ? then cos? difficult.
Ditto for the dense
So the only solution and build it or change un9 of the old series...
I have seen some diy for 8df, and it does not take much to thick I think we want a little more, so far I'm welding.Originally Written by rdponline
ugo ---- president A.E.P.
Watch it doesn't take much to build them, you buy the board, the copper, here in my part 100x70mm paying 2?, make the design of the circuit with paint the ports have a hardware store that also makes the plates and the game and the fact, in an electronics store to buy needles and grafts to the flat, balances everything... and it's done... but if you find a trade already beautiful and done and much faster...
Hello, x-8df I use the old board of the cmd with the cable adjusted to the pin...
Ah sorry I did not grabbed... anyway do you think has the e xxx ori because the old marelli has the same pinout, and then you are going to jtag
Hi everyone, tomorrow I should read a marelli to a 1.3 mjt for the first time,I was giving a look at the various links and I noticed that the power supply of the ecu must be given to the comb, and through the cable with a different pin-out.I was wondering now what is the use of the switch on the output of the various pin,checking with multimeter, I measure always a power of 12.3 volts more or less contact open or closed...known to disalimenta only the white connector on the bosch use to power the adapter of schedule in the spring.I'm if doing something wrong?I'm also inserting the adapter in cdm between e xxx spring marelli and galletto v54.risk something if I am wrong, the position of the e xxx spring?or should not be read only?thanks to all
Write permission
Quote