the reading control unit renault megane 3 1.5dci

[scican25]

hi to all this ? my first discussion here in the forum ! should I map a renaul megane 3 1.5 dci year 2010 !
the car in question is mounted on a control unit delphi I can perform reading and writing in the bdm ?

[msport (exil77grande)]

it was useful also to know the hp of the car, but as usual you are always vague,if it is the 110cv mounts a sid 305 while if it is the 90hp is mounted on a delphi 3.5.

[scican25]

I'm so sorry the car ? a 90 hp with ecu delphi

20140102_160857.jpg the part where you have to enter the e xxx ? in the upper left corner where there are those 14 holes ?
I post also a picture of the e xxx 20140102_161222.jpg

in addition, I enclose a picture to know where to connect the power and ground 20140102_160912.jpg

ecu delphy dcm3.4

[cinqueturbo]

ecu delphy dcm3.4

S? and Delphy DCM3.4 me "seems" we can not do in BDM.. but it is in JTAG Renesas..

[scican25]

so what should I do ? how should I do to read it and then write it ?

[cinqueturbo]

so what should I do ? how should I do to read it and then write it ?

So you can not make it s? the only BDM..
With Gallo v2 or v3, the read and write protocol JTAG Renesas,
or other HW that perform read and write JTAG Renesas..

[scican25]

I have the cock that is also the bdm and in the package c'? written fgtech v50 ! then I can do it or not ??

[ugoboss]

I have the cock that is also the bdm and in the package c'? written fgtech v50 ! then I can do it or not ??

the version of the v50 has no jtag

[cinqueturbo]

So you can not make it s? the only BDM..
With Gallo v2 or v3, the read and write protocol JTAG Renesas,
or other HW that perform read and write JTAG Renesas..

I have the cock that is also the bdm and in the package c'? written fgtech v50 ! then I can do it or not ??

you have to see... select BDM-Jtag and see's? to the protocol...

[scican25]

but I am in the protocol bdm/jtag mode I as a driver mpc55x/56x so I can't do it ??