Hello all,I have an elm327 cable that works perfectly(I use it mainly with multiecuscan..)
Now, or even a cable kkl 409.1.I wanted to understand if modified, could I use this for access to the control units,without the use of adapters.
thanks
Hello all,I have an elm327 cable that works perfectly(I use it mainly with multiecuscan..)
Now, or even a cable kkl 409.1.I wanted to understand if modified, could I use this for access to the control units,without the use of adapters.
thanks
Why complicate your life with these changes then they almost always have problems buying a kit cables and go smooth
Unshared knowledge remains an end in itself.
Would you have a link to a site where you can buy these cables.
Right up to the Admin .there are offers all the cables with 30 euro
I've seen them this cable to make anything and that the adapters are nothing more than switches that pass the signal of the various channels,with a switch I could with a single cable to do everything that is done with three cables and elm,all over here.but I did not quite clear the connections of the adaptors to be able to do everything.Originally Written by 159sportwagon
moreover, the cable kkl I paid 3 euros last year....
Last edited by leandro89; 29-12-2013 at 18:40
On the site of multiecuscan find the plant
Not c'? pi? on the site of the ecoscan. For on the web, you'll find him
In fact,I tried to see but I can't find anything.now I try gogolando a bit if I find something.
I latch on to the discussion..I'm using without any problems elm327 interface chinese on my punto mk2b.
The problem arises when I try to connect to the centrina airbarg and power steering.
Using the cable kkl I always get the error latency is too high (and, of course, I am unable to connect)..does anyone know the settings to use in the configuration of the virtual com port?
I'm using windows xp sp3 + multiecuscan 1.1 registered
Write permission
Quote