I figured it out. But I would like to see that motor where it should act seen that near has nothing to move
I figured it out. But I would like to see that motor where it should act seen that near has nothing to move
write the frame or the license plate of the car that I look
After I provide. Another thing... I noticed that the white gear in a half-moon is detached from the body of the motor and has a slot on the body of the stove... I would Not like it was broken side of the stove where it should be the flap mixer net, and I didn't realize it.
may be, in case you have to remove. make sure well before proceeding.
Even why? I think c'? that white gear is needed for the climate controls manual where to place the starter motor in order to move the posts to there is another mechanism
Hello. I solved the problem of the door, now it works. But.... L hot air does not come out the same. Any idea?
Last edited by leandro89; 17-11-2013 at 12:56
Hello to all purei I had a customer with a similar problem, and at the command of the owner, after having presented the prev expenditure for sistermarla well, he told me to do something to spend a little, I changed the headstock fissandogli a race by way of acting manually by placing your hands under the dashboard on the passenger side and open and close the heating....you punch the pin output of the headstock that deflects the air.
....sorry to make this work I have put in the account of two tubes of voltaren....I had to do the contortionist to fix it
Hello so to me, it was sliced down the pin from the motor goes to the pallet. L I arranged did warm up the machine, but nothing... Then I removed the filter anti pollen ? slipped her fingers behind and going to touch the radiatorino I realized that it was cold. I go in the engine compartment and touch the tubes that go to the radiator and son hot... I Think at this point, and have the radiatorino clogged
I know that is not a conventional practice , but you can try to disconnect the two hoses that go to the heating from the engine compartment and try them out inside with a compressor, first floor, and then with more force.Originally Written by oakley1
Hello so to me, it was sliced down the pin from the motor goes to the pallet. L I arranged did warm up the machine, but nothing... Then I removed the filter anti pollen ? slipped her fingers behind and going to touch the radiatorino I realized that it was cold
ugo ---- president A.E.P.
You know that the gears have the established position when mounting on the motor? If it is not respected, the motor works with the wrong position and it does not work!!!!
Write permission
Quote