Delphi DCM3.7AP and Galletto 2 V53

[corrado]

anything you do not want to read this damn Delphi , do you have any advice besides throw it away and change it ?


thanks

[frantik3]

and for sure that you have a chinese as many v53, not to be the jtag there are many of them around!!!

[corrado]

and for sure that you have a chinese as many v53, not to be the jtag there are many of them around!!!

and yet I was sure to have a good one , if you place the photos you know you recognize it ?

change the date to the pc or use some sw to confuse the program of the cock.

Use a hard disk with xp only (date 01/01/2013) and with only the folders about the FGtech , niennte of pi? ....

Can you think of something else .

Not c'? no one in the forum that personally it has made with the clone ?

[ugoboss]

change the date to the pc or use some sw to confuse the program of the cock.

[ugoboss]

then use an external hard drive with xp, connected to your pc, try to put the date is also on the first pc to 1/1/2013

[corrado]

then use an external hard drive with xp, connected to your pc, try to put the date is also on the first pc to 1/1/2013

no , the change precisely in order not to create problems , on one I have win 7 and x fgtech win xp

Another question : to make the 7 jumpers (links) as shown from the diagram that I attached , you like them made ? ... performed with the wire or the united with a point of the pond from part to part ?
I would not like do not read both depend on the welding is performed with soft wire ...

C'? some holy light that can help me , I have this ecu on the bench and I have to replace it to the pi? soon .

Thanks !!!

Reassembled the unit , after the fourth attempt to weld not ? changed nothing ! the reading has not even started ...

I noticed that the ecu ? the same as the GM-Opel / Hyundai-Kia / SsangYong - Delphi DCM 3.7 R5F7

On the cock that I have the SsangYong pu? also be done in the obd , what do you say ? the same, or ? better not to try ?

[corrado]

try to read it, and then evaluate

nothing no even go like this :-(

[corrado]

I've noticed that in my control unit c'? a component smaller than the one shown in the picture in the documentation Fgtech attached previously .
here I attach the picture of my ecu with the highlighted component in the less

[frantik3]

you should open and see how they are made from the inside if you give me a permission to post the picture of the inside of 54

[corrado]

you should open and see how they are made from the inside if you give me a permission to post the picture of the inside of 54

Hello Frantik3 ,
maybe you are grateful for .
Not ? that head may be times when you also give a look to the photos that I have already? posted in this discussion of my unit , it seems to me that it has a component different than the photo shown in the documentation of the FG-tech.
Thank you and good day

Hello Frantik3 ,
maybe you are grateful for .
Not ? that head may be times when you also give a look to the photos that I have already? posted in this discussion of my unit , it seems to me that it has a component different than the photo shown in the documentation of the FG-tech.
Thank you and good day

in the meantime, I am attaching the photos of what I did , let me know what you think ?

you should open and see how they are made from the inside if you give me a permission to post the picture of the inside of 54

hello Frantik3 , you've got to take a picture ?