Programmer Upa

[gezame]

but there are different kinds of scripts?
Thanks for the info, are the first steps with the UPApa

Hello
Yes, they are different, some for inmo, the other for the pin, the other for miles, etc.

[gezame]

for reading, you always have to unsolder
otherwise, how do you correct a reading done wrong?

Hello
No, no you have to unsolder, some eeprom you can llere with the caliper, and the other not.
You will only need to asicurartti here the reading is good.

[matech]

Here, then, such as the eeprom are read with the caliper?

I simply try to read most times and see if the check ? and always the same. But this does not protect you from being able to corrupt the data, but...

[cinqueturbo]

Hello
Yes, they are different, some for inmo, the other for the pin, the other for miles, etc.

gezame, but where to find them?

[ecutuningpro]

you better get to unsolder always, read with the caliper of the chip soldered on the board many times ? busted.

[linus146]

I see so
at least at the beginning you make of the readings is with the caliper that can be seen
then when you're reading done well by a hurt, you can also read directly only with the caliper
p.s. to me pocp time ago and asked for a reading that seemed to be well made, but it has left a string, all ff ff ff ff ff
and was that where there was code key

[ecutuningpro]

on purpose to avoid problems of the kind I prefer to unsolder always.

[linus146]

in fact,................

trust is equal to rub--------

[michele30]

c'? a guide (or manual ) of this upa on how to connect the calipers to read or even to unsolder and which player esare ?

[linus146]

you how to install the program there is the guide