Problem alfa 159 120 mjtd

[gcmotor]

I'm sorry if I answer you now. No car stops accelerating was not a defect. Only in the tip with the car in acceleration, with the engine load, so the " shake ". Then again, I replaced both the flywheel and the clutch and the car was fine, both in golds that mod

[voglioimparare]

email the file to the machine, so we will ensure that the mod is ok and the egr was closed properly. in addition to that smonterei physically the egr to see if stuck open... it wouldn't be the first time that happens....

[nasone147]

could also be injector!not ? simple from far away!try to be more? scupoloso!find the flywheel,since the f? the acceleration is gradual and abrupt no!

[max boost]

The engine is shaking moves as if to go and 3 both at idle and in gear

sorry freddyecu but at this point on how the story seems to be + a seghettamento that a traballamento from the flywheel...I ask a foregone conclusion before the mapputura did it? sometimes increments that start too early cause jerking similar, but in fact without seeing the map ? impossible to help you could be a thousand things...ah obvious if it has started to do this after + easy that it is a failure

[tezzero]

we have a few indications..mail the map

[6bazz!]

Hello, if I understood well, I have the same motor on the brera (2.0 jtdm) and maybe I have the same problem. Pi? that a vibration I feel like a singhiozzamento of the engine around 1500 rpm which affects the linearity? running of the car. You hear a lot if I keep the same number of turns while accelerating scomapre any faltering. I have the original mapping.

[ugoboss]

Hello, if I understood well, I have the same motor on the brera (2.0 jtdm) and maybe I have the same problem. Pi? that a vibration I feel like a singhiozzamento of the engine around 1500 rpm which affects the linearity? running of the car. You hear a lot if I keep the same number of turns while accelerating scomapre any faltering. I have the original mapping.

it's not quite the same engine, you have the injection, which belongs to the same family, edc16c39, and also for you, the speech is similar ,and a lot of effort to make a diagnosis on a forum, I advice you to do try the car to a good mechanic with experience on these cars, and the problems can be many and only trying it out sometimes you can't figure out where it comes from.

[rts]

I would try to faren round with a diagnosis attached and check the parameters to see more?, in diagnosis there are errors?