exclude the egr on the alfa 147 ecu edc15c3

[msport (exil77grande)]

here it is all up to 12000

so we should be

I have not seen the file, but if you have to put the maximum value that should be 12740 and you've set to 12000 the file is incorrect and the egr will always be a little bit open.

[zaga1]

ecusafe does exclusions egr.

I'm sorry, msport, but I was wrong to write in the confusion sometimes can? happen ;-)

Thanks zaga1 but are the first weapons, and the graph in 2d I don't read well yet

In essence, opening the voice, egr duty cycle, or injection phase, for example, first open the chart without modifying anything, and you'll see a red line that he did****lli on the basis of how the file is ori ? set to generated, but once you change the values all at 12740 retry to display the graph and you'll see that the li ea red sar? straight until the end, and begin perhaps to understand what is happening a vokta closed the egr on the 2d map and you say to give you a clue since I can't yet post anything to make you see the difference between ori and egr closed on the 2d test and let me know what do you notice as the difference by changing the values of the table ;-)

[gizmo]

I was told to do so, the file had tuttivi values 12740..... which values you have to put?

Thanks zaga1 Monday? he returned to the house to do?

[zaga1]

Thanks zaga1 Monday? he returned to the house to do?

Nothing gizmo we are in a forum ? right and a duty to help others where you can? ;-)

[gizmo]

Thanks! !!!!

[audi sp]

I usually over a 2-bit from the tap to the controller..I always put everything to 12000, and it has always worked... or better.. this should work

[gizmo]

Guys sorry then, I just thought I need to 12000 a 12740, and I have to tap the other?

[Alfa159 q4]

You have to bring everything to the max value! Then make 2 accounts.
Audi sp if you tap the switch, you can also do other than move the duty cycle..

[elettro72]

it seems to me that you can't see all ste domande...........in edc 15-just take everything to the max value of the map in the ecm called phase iniezzione that your ? set to 12740 and then brings everything to 12740...........

[gizmo]

it seems to me that you can't see all ste domande...........in edc 15-just take everything to the max value of the map in the ecm called phase iniezzione that your ? set to 12740 and then brings everything to 12740...........

Hello elettro72 if you see the file in the first post and everything 12740 me and was told to change it to 12000 also made this change now carry everything in 12740