on all the edc16 last ? the back, however you can moddare also that ahahaha!
on all the edc16 last ? the back, however you can moddare also that ahahaha!
Right!!Originally Written by SandroMarciano
I'm lost in a pikeman of water!!!!!
if I took an example of another EDC16 that the drivers or maybe I did not inceppavo
maybe I can even understand the DEC?
or tried to understand something with winols, but I abandoned it and I have to reinstall it..
what do you mean by "dec"?
What do you use to understand what are the values? X-Y-Z-DEC
DEC ? the value in decimal.
the conversion factor in the torque limiters for all the edc16 ? 0,1
so if in decimal you have 2500 and multiply it for 0.1 get 250, the cio? the value of NM
[COLOR="#0000FF"][CENTER][B]In life you never stop learning![/B][/CENTER][/COLOR]
[CENTER][COLOR="#FF0000"][B]I do Not answer to private messages with requests for help! If you need a hand, ASK ON the FORUM!!![/B][/COLOR][/CENTER]
and for the map lambda?
how do I do if I don't know where? the head and tail?
ZZZAAACCCKKK and away???....
you quoto, cos? understand how to interpret itif I took an example of another EDC16 that the drivers or maybe I did not inceppavo
[COLOR="#0000FF"][CENTER][B]In life you never stop learning![/B][/CENTER][/COLOR]
[CENTER][COLOR="#FF0000"][B]I do Not answer to private messages with requests for help! If you need a hand, ASK ON the FORUM!!![/B][/COLOR][/CENTER]
You gi? I'm working in that direction....
Of the truth??
not de eloping a laugh?
for the lambda value multiplied by 0,0145 get the A/F ratio, for which the value of 1000 corresponds to a 14.5 parts of air to 1 fuel.
Ok!!!
we hope that we have perceived your advice,
what do you think?
Write permission
Quote
