info, read and write edc 15

[michele30]

tomorrow I should read a lancia phedra with edc 15 with kess clone and magpro2, do you know if there are problems in lettur ao write on this machine or can I go quiet , the usual tricks?

[SandroMarciano]

Mag pro ? the best tool for edc15, but if you set the option to speed? pi? slow you should have no problems!

[michele30]

both in writing and in reading?
if you block these I know that you do not in bdm, you must unsolder?

[legendaryslave]

both in writing and in reading?
if you block these I know that you do not in bdm, you must unsolder?

you must unsolder the 29f400 but ? very difficult for the blocks you can go quiet, even with the cock 1260

[giarras]

as you have suggested, with a magpro, go mode? slow.

[michele30]

we always talk about writing to go at a moment's notice? slow, why? in writing, I leave what I set the program to
also on the edc 15 we want to 40/45 minutes?

[giarras]

we always talk about writing to go at a moment's notice? slow, why? in writing, I leave what I set the program to
also on the edc 15 we want to 40/45 minutes?

no,edc15 a couple of minutes.

[SandroMarciano]

we always talk about writing to go at a moment's notice? slow, why? in writing, I leave what I set the program to
also on the edc 15 we want to 40/45 minutes?

here make sure that it is mode? slowly, I stuck edc15c7, then resumed with mpps writing the whole file...

[msport (exil77grande)]

if you're using an measures in reading, you have to do as well in writing, you can't do a thing one way and the other and so incasinate things and then locked the ecu.

[bart]

tomorrow I should read a lancia phedra with edc 15 with kess clone and magpro2, do you know if there are problems in lettur ao write on this machine or can I go quiet , the usual tricks?

I have tried long ago to read it in the OBD, but I could not, as the framework will be turned off automatically before the tool to finish to read the map!