I wanted to act on all values above 600bar where I changed the time, I had to anticipate to 3.5? some points to the maximum of iniezio and while and 4000-4500 also to 70mm3 I have to postpone antici original too high
Certainly using ecm titanium with the correct number of hw and sw ? ok, to compare, I also did the calculation of the absolute value of time is the factor conversionee returned to the calculation delntitanium
Certainly using ecm titanium with the correct number of hw and sw ? ok, to compare, I also did the calculation of the absolute value of time is the factor conversionee returned to the calculation delntitanium
here's how I see them, and at 4500 rpm to 70mm2 use the break of the 80mm3 and I see that an injection of 975 us to 1600 bar, which is 26?, here it would not make sense to anticipate the post-injection must have a minimum duration nodevo be between a minimum range of 4 degrees after the mps about 7-10 after the tdc in order to have an optimal combustion?
or another example
when an injection-15mm3 at 4500 revolutions are about 660 us, in degrees, 17.8?, but here the advance ? 21?, ? absurd, that is, the end of the injection ends before tdc, so here I postponed the injection of 5? as for 15us are 840 bar and the value closer to 800 bar), I had increased tramiteb tables times from 540 u.s. at 647 us and so also with the increase of the injection time is too early, according to you ? wanted this early? for what reason? you richisa detonation before the time of need here, and then loss of potrenza
Write permission
Quote