good evening everyone I wanted to ask you since I bought mpps v12 to try it out I read a map of a opel zafira 1,9jtd120 cv when I go to select the vehicle nn I from the 8 valves but only 16 v I ch the ecu ? an edc 16 c9 the law but I can write it cm never?
c9 or c39? have you tried to read it with the c39?
yes I tried in both ways the law but nn writes the original file which is his greatness?
the file opel zafira 120 hp ? 2,048 mb
mpps reads the file of 1m only tables.
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
I don't want to put myself at odds with anyone I just want to say my experiences, I have worked both on the 120 hp and is on the 150 hp and in both cases on the first file to 1mb, and on the second file, 2 mb with mppsv5 I have read and written easily the ecu greetings to all and good job
if the sw does not write it means that you do not ? supported not center version 5 and the v12, then alternatively you should always have inside if you want to do this type of work various interfaces es: mmp, galletto bdm. magpro, etc, etc, let us not deceive ourselves with a simple interface, we can do it all.
I cpito but cm never connects c'? has done it? thanksOriginally Written by alex68
are not all the same, I have also heard to say that some version of these ecu programmed before may of the year following that you can rewrite,
I repeat only heard you say I can't confirm.alternatively e-mail the data of the ecu sw and hdw year etc.
es: last week galletto 2 on the fiat croma 1.9 read ok, write, nothing, tried again with mpps all ok reading ? writing. that's why? I am of the opinion that in a repair shop that works on the ecu, we always want to almost everything. from bdm at mpps from the soldering station to the programmer. etc etc
Read and written as the opel zafira 1.9 16v cdti bosch edc16c39 can as a protocol does not exist in the mpps 8 v file 2 mb
Write permission
Quote