Recognition ecu bosh from the label and wiring diagram FGTech Galletto

[robby51039]

I have a question for the reading in the boot or can the resistance it needs to be carried us or are internal to the rooster?

[klajdin]

I have a question for the reading in the boot or can the resistance it needs to be carried us or are internal to the rooster?

in my case with the rooster clone 3-led are present in the connector of the cable boot ( and it works !! ),
but I think that in the original should stay within the interface, I say " I believe " because I have never seen the ori
just check with the tester, the resistance between the two wires of the CAN and between the wire BOOT and the mass of the connector is disconnected from the interface.