I confirm that I have a file in the bdm and solve,for my experience on these cars always bdm!!
I confirm that I have a file in the bdm and solve,for my experience on these cars always bdm!!
You do not really understand something until you can explain it to your grandmother (Einstein)
ok thanks for the advice all, at this point, then I turn to the specialists, I try the file in the bdm for ford focus 1.6 tdci 90 hp here is the data of the ecu:
VIN Number :
Bosch Hardware Number : BOSCH EDC1
Bosch Software Number : 0081A010:1
Ford Hawdware Number : 9643626080
Ford Software Number : 500B050203
thanks..
enter the file golds that you read with mppsOriginally Written by giulianoA3
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
I don't know why I can't enter it!!
look at that you ? send pappy ultrafast time-and on Sunday evening http://www.professionalchiptuning.ne...5181#post35181
try to write with the 2 in serial see if it starts again as the cock on these ecu is reading the entire
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
hello, I do not have this cable:at 2, where I can find it?thanks..
I'm sorry I made a mistake I meant to write the galletto 2 to avoid to open the ecu otherwise open, and go to bdm
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
possibly the galletto 2 where can I find it?thanks..here on the forum you want to sell?HELLO
hello, nothing to do, the ecu does not want to know..bdm says error connection ecu!!any suggestions?hello thanks.
just last week I due to resume in the bdm. Which bdm uses ? if you use the bdm100 software 1255, I can say that I had problems too, so much so that I've had to resort to the software of the dimsport ( what ? also pi? old) since? only with this last scripture ? come to a good end. with the 1255 told me that it was necessary for the complete file, even though I had a backup of the same car.
However, check carefully to see that there is no contact between the schedule-spring, and the plots why? just a little movement out of the office not to communicate.
Write permission
Quote