Problem ford focus 1.6 tdci 90cv ecu locked!!

[giulianoA3]

hi, at first my experiences, I find myself with a control unit definitely stuck!!!I did the reading with mppsv12, at the time of writing the block, almost immediately just launched!!I also tried with the cock,but nothing, I do not want to know..the car won't start..
some acquaintances have told me that this type of control unit is not responding facilmente.Ho discovered that there must be some cable that sends short, the system of the car because if you stand still for one or two days, the battery in!!seccondo you you you can recover?immaggino bdm!!??I am not in the fo te ns pla mpe!!
I enclose the data of the reading:

[giarras]

you have not attached anything..but if you are a novice and as you say you do not think we can solve the problem you can turn to the service offered by the forum, you'll find well-trained personnel available, you may want to contact them:
http://www.professionalchiptuning.ne...o-Files-Online

[giulianoA3]

thanks for the response..'ll keep account of your sudderimento..
I can't seem to attach the file

[legendaryslave]

but before loading the map started? if ? so only bdm you save

[pinotec]

hi, at first my experiences, I find myself with a control unit definitely stuck!!!I did the reading with mppsv12, at the time of writing the block, almost immediately just launched!!I also tried with the cock,but nothing, I do not want to know..the car won't start..
some acquaintances have told me that this type of control unit is not responding facilmente.Ho discovered that there must be some cable that sends short, the system of the car because if you stand still for one or two days, the battery in!!seccondo you you you can recover?immaggino bdm!!??I am not in the fo te ns pla mpe!!
I enclose the data of the reading:

find a file of your ecu bed in the bdm ,and write it in fgtech2 or mag, you will see that solve

[Gia]

hi, at first my experiences, I find myself with a control unit definitely stuck!!!I did the reading with mppsv12, at the time of writing the block, almost immediately just launched!!I also tried with the cock,but nothing, I do not want to know..the car won't start..
some acquaintances have told me that this type of control unit is not responding facilmente.Ho discovered that there must be some cable that sends short, the system of the car because if you stand still for one or two days, the battery in!!seccondo you you you can recover?immaggino bdm!!??I am not in the fo te ns pla mpe!!
I enclose the data of the reading:

from what you say, you have had the low voltage. For this you ? locked.

How much voltage was reading the mpps?

[pinotec]

from what you say, you have had the low voltage. For this you ? locked.

How much voltage was reading the mpps?

this is not a voltage problem, and a problem of mpps..already happened on the same car
recovered as described above

[giulianoA3]

but before loading the map started? if ? so only bdm you save

hello, after reading the car partiva.dopo the test write no more.

[giulianoA3]

from what you say, you have had the low voltage. For this you ? locked.

How much voltage was reading the mpps?

the tension was on the green, and then in the standard 12 and something...usually it seems to me when it goes below 12 volts, it becomes red.

[giulianoA3]

find a file of your ecu bed in the bdm ,and write it in fgtech2 or mag, you will see that solve

then the file that I read with mpps writing in the bdm is not good?thanks.