eprom programmer,what to do

[sportknight]

but the xprog does not have the adapter for eprom zif 40-pin?

[sportknight]

ragazziiiiiiii,then? qualce programmer should I take?
the willem no, why? does not communicate with the usb port, but only through the parallel port
the xprog ? the one that has more? adapters and costs very little, but I have not seen the adapter zif 40-pin
then I saw the cinesone that costs very little,no one has it? ? the lag g540 with 2 or adapters plcc32 and plcc40
need those adapters? or are more? useful those who give with xprog?

[alfajtd]

according to the eprom, eeprom, micro, etc... that you have to eventually make purchases...

who do you serve 2 of programmers who each other are offset...

[sportknight]

ok thanks

[progresso]

I have the upa that usually use for the drivers and I am fine for the engine control units never even used because I just started with the tuning of the ecu, however I advise you to see the car park you have then if you have money to throw away like others said buy 2 so you compensate

[sno74]

I also use I have g4 upa and xprog but go quiet g4 works well and has a price that is not an exaggeration.....

[sportknight]

between the upa and the x-prog to begin what would you recommend for me?

[maku1977]

I use a GQ-4X ... simple with fequenti updates..... and never misses a shot!

[sportknight]

Azz, I'm confusing the issue even more ideas

[klajdin]

Sportknight I have the upa and tl886cs with almond eyes and the last quest I got it with all the adapters that were also normal that costs more? so if I have a problem with some EDC15 out the flash and do the same cmq cmq not enough the same, it would take the xprog to cover a p? pi? the motorola.
According to me you need at least 2 programmers, the cio? I speak of the clone, where the price ? enough content x who does not every day, senn? of programmers as good as you ? gi? was advised there are but the normal prices are more? high.