but if this is only a test, why not make a total directly in the serial?
but if this is only a test, why not make a total directly in the serial?
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
and with that program? I've seen that time and carsoftware support scodifica of edc15c alfa romeo.. nyo4?
the meucci the fa already tested
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
Ok thanks guys
The code is located in part on the 95P08 and in part on the flash.... depends on your chances? if you can do a partial do it on the e2p, otherwise you do the full flash serial....
Guys but to make the scodifica total from the serial port, just connect the MPPS or the Rooster v2 to the OBD as if it were a simple writing? Or you have to follow a precise pattern? I have to say that the ecu that I have to scodificare doesn't have his own key so I should scodificarla in serial bypassing before the immo and then write the file scodificato.
Thanks to all
You must do the reading then treat the files read for example with carsoftware and then perform the write.... Keep in mind that carsoftware does not correct the cks .. pay attention you may want to block the ecu....Originally Written by carbo92
x the total by obd is on the flasks, and then calculate the cks ( lights are on the usual engine and code )
Carbo for the total you need to follow the steps of removing the 95p08, otherwise you can not read it on the bench or dissaldi the 29f400
Sometimes it is not enough to exchange the 95p08, but also the files of the flash.
Another procedure: NB you have to have a device that reads and writes data in the control unit.
procedure to tour:
original unit, which connects the hw to the connector and read the flash.
Take the control unit of the collapse, open it and remove the eprom 95p08 (8pin smd). connect the hw and read the flash, save it and then reprograms the flash read in the original unit. (This step you need to bypass the code for reading from and writing to the control units recovered, but does not work on all units).
now a firm 95p08 of the original unit. clone ok
Write permission
Quote