Hello guys..I open this topic to ask you for information,help and your experience on the ecu mikuni-made by kokusan which mounts on one of my many bikes and the cio? a husqvarna SM610 2005 carburetor...
the problem,if so? you can? call,? that this bike ? gi? been much modified by me with several jobs, including a kit plus the HTM racing carburetor mikuni fcr from 41mm air filter and airbox moddati,full exhaust arrow titanium,final reports reviewed,etc,etc... and of course a ecu magazine from the same HTM racing Milan with rev limiter moved from 7500 rpm gold medals at the current 8100rpm....now since the bike c'? l? stops for bad weather, and again, I have a p? more I of time ****** I wanted to dedicate myself to the mapping of this ecu maybe further shifting the rpm limiter to 8500 rpm, and reviewed a p? the curve of the ignition advance in the prediction of the mixture, p?? push that can give me a little more? especially at the top also seen that monter? the cams of a husky te610 which should give me more shooting at the range...opening the ecu,expecting to find a micro more "human" I came across this is the result:
I was hoping to find the eeprom to desolder and read, but the bad news ? the processor ? a H8/3687 of which s? nothing, and therefore I believe that ? impossible to read with a simple eprom programmer!
who gives me some advice about it....
aahh..the bike ? this....
here ? immortalized in a step of the base...now the bike ? completely different.....
even if it does not turn more practically for the public roads...every time I shake a p? the buildings of my country....
Quote
