Alfa mito 1.3 90hp off the DPF and EGR

[maxpaine_1]

Good morning to all.
I created the file with a time sensor...
I made the block of the egr MJD6 and I saved the file
after I reopened the file you created and I did:
the deactivation of the dpf by selecting MDJ6.
and I resaved the file...
I'll post the file, if someone can? kindly check to see if everything is ok.
thanks

I put the file in cem titanium x to cut it, but I do not recognize the driver... the original...

[maxpaine_1]

I put the file in cem titanium x to cut it, but I do not recognize the driver... the original...

I managed to cut it to 1 mb with the ECM.
and I generated a file from 1mb... (.cnk)
a question, the other part of the file, the mb cut ? empty? serves no purpose?
now the problem is with ecm titanium and it tells me (no driver compatible with the selected file)... what ? success?
before writing it I have to do... control checkusum....

[rego88]

I if I were you... I would trust this to a professional and pay him.... if you row all smooth, you've saved what you ? was good.... but if you nail the ecu with mpps.... after rounds whistling.... for how much you hurt your hands!!!

[explode82]

the you just have to write,and ? normal that you see the titanium,since for him the greatness ? exact

[explode82]

rego to leave I am of the opinion that everyone must do their experiences com'? just the after ? another story

[maxpaine_1]

hello and thanks for the response.
also putting the file 2 mb does not recognize it anyway.
however, leaving aside the map for now I can live without it, the file that I posted to remove dpf and egr ? exact?

[msport (exil77grande)]

in the pm surely the most? someone helps you

watch that your advice is absolutely out of place,in the meantime, we help all in the light of the sun free and second if you want to learn you put good will, and we give them the right to be straight and it is only then if you try the jelly is ready, there is the on-line service of the forum speria is clear for all this is because some of the attitudes they give me a lot of hassle.

[maxpaine_1]

Having your advice... and your recommendations... I think I give up this experience, I think that it is too risky, even if I have the right tools for the hands.

[Backgroop]

Having your advice... and your recommendations... I think I give up this experience, I think that it is too risky, even if I have the right tools for the hands.

Whenever you work with the changes to c'? the risk, ba you have to take risks to learn..
your problem is that you are unable to open the file with the ecm.. but be careful if you don't open the original ecm does not recognize? the driver, if you want to open directly the modified selected the driver manually, go quiet on these ecu's the risk that you block ? low..

[maxpaine_1]

Whenever you work with the changes to c'? the risk, ba you have to take risks to learn..
your problem is that you are unable to open the file with the ecm.. but be careful if you don't open the original ecm does not recognize? the driver, if you want to open directly the modified selected the driver manually, go quiet on these ecu's the risk that you block ? low..

hello.
I managed to make the file to 1mb with the ecm... but they all keep saying that the time does not do the complete job (egr and dpf) and with the mpps c'? the risk of the write lock, and then pain...