file info *.mpc......

[Emanuele54]

Hello all,
I'm looking for, lately, especially in the mjt (e.g. grande punto 75/90hp) that when I read with magpro2 V4 I create 2 files, one normal that corresponds to the one you want to modify and a second with the extension "mpc" that very probably ? the file that handles the microprocessor......


now I would like to know if someone s? if I were to write the file to the above-mentioned another control unit, the bloccherei?
then mpc files are the same for all units of the same cars (ex. GP90cv they all have the same file mpc) or are they all different? and therefore I have to have the mpc file for each controller?

Thanks

[Giacomo]

because you have to complicate your life? each ecu that you always do the reading backup

[msport (exil77grande)]

of course, the mpc that laws can only use with that type of hw and sw.

[Emanuele54]

Hello, the fact ? that if I wanted to clone an ecu?
Thanks

[admin]

Hello, the fact ? that if I wanted to clone an ecu?
Thanks

If you need to clone it, you need to read the backup of the control unit, and then write it on the other

[panny200555]

If you need to clone it, you need to read the backup of the control unit, and then write it on the other

even if the number of hw and sw of the other ecu ? different?
for example: a edc16c39 to clone it on another ecu ? edc16c39 but with hw and sw is different..

[tronic]

no you can't hw and sw should always be the same

[panny200555]

hmmmmmm....thanks for the info!

[explode82]

Or, at least, hw and sw should be very similar, but always try

[tronic]

believe me that if hw or sw are different, the control unit does not find the input or output of any signal