Which interface to 1.3mjet

[bart]

I would like to read/write a couple of Fiat 1.3mjet (in particular, a Panda and a Great Point).
In the software MagPro there are 3 versions of the point 1.3mjet, but not the panda. Also I read in a post here on the forum, of someone who had had problems between this interface and these control units.
Then I would like to kindly ask you which interface would you recommend for me to read/write these ECU without any problems.
A further unknown ? I don't know which version of the ECU montano (as the cars in question, but have not yet seen), I just know that I 1.3 mjet...
Thanks for the help and advice...

[magi1984]

surely BDM go without a broken boxes

[bart]

Thanks magi1984 for the reply!
It is just a BDM100 or serves a Ktag?

If I wanted to instead read them without opening them, maybe directly via OBD, that tool tips?

[jolidj]

you do it with the bdm 100 nn if and marelli 8... a serial port you could do with the mag write only if nn mistake.

[sportknight]

the marelli 8 are the latest?

[msport (exil77grande)]

a mpps, and that's more than enough.

[bart]

you do it with the bdm 100 nn if and marelli 8... a serial port you could do with the mag write only if nn mistake.

So with BDM100 you can make all the Marelli?
As a gi? asked by sportknight, what are the 8? Where they are mounted and how to recognize it?

Sure MagPro can only write? The pu? do without problems?
And how to do it with the Panda 1.3mjet, which does not appear in the list of supported ecus?
Thanks for the clarification!

[sportknight]

even with the mpps some can only write and not read..

[bart]

a mpps, and that's more than enough.

Thanks msport!
So for these units best to obtain MPPS and leave it in the drawer MagPro?
With MPPS you can make all the 1.3mjet and Marelli in general?

[bart]

even with the mpps some can only write and not read..

Are you referring to the ecu Marelli for 1.3mjet, or in general?