Limiter turns on edc16u

[saivivere]

Guys, nobody can help me?

[magi1984]

I have searched on the web but apparently the limiter is really in the eeprom, and no one said how to change it, sorry

[msport (exil77grande)]

http://www.mediafire*****/?4bsvcdbnvqja9lv

here is the link of file ori + mod golf limited to 4000 rpm. Thanks in advance for the help

hello,the first thing the next time upload it on the forum and not outside because they need to see just completely average users as required by the regulations otherwise it would not make sense,I looked at the map,then, for me, completely redo the fuel injection,completely redo and in the first break point you escaped the mouse with a peak in the negative,torque limiters I do not like at all,increases in the negative on enrichment and acceleration, and still hurt,even the turbo maps are completely unpacked,I wanted to know, but limited to 4000 rpm in 6th gear at the maximum or up to 4000 rpm with all of the gears?
according to me it depends on the map.

[saivivere]

hello,the first thing the next time upload it on the forum and not outside because they need to see just completely average users as required by the regulations otherwise it would not make sense,I looked at the map,then, for me, completely redo the fuel injection,completely redo and in the first break point you escaped the mouse with a peak in the negative,torque limiters I do not like at all,increases in the negative on enrichment and acceleration, and still hurt,even the turbo maps are completely unpacked,I wanted to know, but limited to 4000 rpm in 6th gear at the maximum or up to 4000 rpm with all gears?
according to me it depends on the map.

Thanks for the response msport. First of all, I apologize for the error with the file upload was not my intention ? only that I had not seen that there was the mode? advanced for it to load. I didn't believe I could do it being still a beginner. For the map, I made it myself so I give you fully reason I do not like it, the problem for? ? any gear enters the limiter at 4000 then ? as it says in magi1984, ? limited in e2p.

[msport (exil77grande)]

Thanks for the response msport. First of all, I apologize for the error with the file upload was not my intention ? only that I had not seen that there was the mode? advanced for it to load. I didn't believe I could do it being still a beginner. For the map, I made it myself so I give you fully reason I do not like it, the problem for? ? any gear enters the limiter at 4000 then ? as it says in magi1984, ? limited in e2p.

the attachment is quiet,for the limitation I repeat that everything is possible, but a lot of 1.9-2.0 tdi edc16 that I did except for a few 140cv that had a speed limit in the e2p and not more than 210kmh I never had or heard of limitations to 4000 rpm even with all of the gears,tell me something with the file gold if you try to sink limits as well to 4000 rpm with all the gears?

[saivivere]

you, the tests were done also with the file ori and limits the same to 4000 rpm, only in first gear, unable to go a little further, but only because? not much load, however, tomorrow morning I have to read the file with the bdm and then send it to a friend for editing, terr? informed.

[saivivere]

So guys, nothing to do, after reading bdm and did change the file e2p to the people who trust the golf fails to go over 4000 rpm and then nothing. Thanks to all for the help.

[frantik3]

limited to 200km/h!!!!!!!

[frantik3]

and I have also seen that to remove a phantom limiter has been used ecusafe

[frantik3]

the map does not express myself even if some of the comment you had