first map bmw edc16

[munro]

the Z-axis, the other not ? that the contents of the map...if, for example, to display the map in a grid see very well that the outside of the table itself, you will find two columns,one horizontal and one vertical, which are highlighted in gray..those are the x and y axis...while the contents of the table and the Z-axis...these are the names for? you use them if you view the map in 2d.....
you for the "then" I am referring to from 50% to 100%...
for dw the incremto in percentage you can? do safely...
the important is to adapt the lim of torque at the request of the Dw....
and then adjust the other limiters...I am referring especially to the map conversion nm to iq..
and you have lim fumes or maps lambda on the basis of maf(mass air flow sensor) and map(turbo pressure)...

[E92_mpower]

perfect all clear, proceed a couple of things for a time, otherwise I do mess
then along the Z axis are all the parameters in the boxes of the X and Y axes
called respectively the rpm/load
and then where are all the parameters
mapparail.jpg

[munro]

exact.....for? I repeat these names are mostly intended for the visulizazzione 2d and 3d....

[E92_mpower]

obvious, between a p? I come back home I change the file from scratch and then map the stock and I'm going to increase as I've told you.
and place the map

[E92_mpower]

edit made you put the images

torque limiter mod.jpg2d enrichment acc.jpg
in practice, I've increased both the enrichment in c. both the torque limiter of 200 points.
see if I did well, otherwise the 20% increase in

I can't find anyway no voice NM/IQ

[munro]

modest increases in....this car that the gearbox mounts? manual or automatic?if ? automatic you can leave it like this ... if the manual you can dare a little more....

[E92_mpower]

modest increases in....this car that the gearbox mounts? manual or automatic?if ? automatic you can leave it like this ... if the manual you can dare a little more....

bmw535d there is only automatic
then 200 points have to be well ok...
while the map conversion nm to iq I can't find it...
what do I do I do with the press and limiter of the turbo?

[magi1984]

you can find it by examining the 2d map from the address d7644 then

[E92_mpower]

but in 2d I can't see anything only the beginning of a curve

[E92_mpower]

you can find it by examining the 2d map from the address d7644 then

I select all and increase??